Ariens 924040 Snow Blower Category

Original Model: Tecumseh 8hp HM80-755128E

This engine has a 1" x 2-3/8" shaft on it. If you buy an engine with a smaller shaft on it, you would need to buy a sleeve to go to a 1" shaft. If your key stock is built into your pulley, the sleeve will not work for you.

Parts List

1 Products

Sleeve-34-1x220-Key

, 2.20" Long, to go from 3/4" shaft to 1" shaft including a stepped key from 3/16" to 1/4", Unbranded

$19.95

In Stock:28

Questions? Email us directly:

Required Fields *

General Disclaimer

While we may have sold many engines listed above to be used for a Ariens 924040 Snow Blower Category, we are NOT claiming these are exact replacements unless the product notes explicitly say so. Many original equipment engines may no longer be in production because of obsolescence or EPA regulations, so in some cases there may not be an exact replacement available. Our intention here is to show that other customers have utilized these in the equipment shown, but may have had to make some modifications to do so. If we know of any required changes, we will list those, however, some adapting during installation should be expected.