John Deere 828D Snow Blower Category

Original Model: Tecumseh HMSK80-155667V and HMSK80-155559T

These engines have a 1" x 2-3/8" shaft on them. If you buy the Briggs OHV replacement engine, you will also need to purchase the sleeve and keyway set and the mounting base plate to replace the Tecumseh engine.

Parts List

2 Products

Mounting Base

Mount-BS-Tec

Engine mount plate, 1/8" thick, to replace Tecumseh HM80-HM110, LH318-LH358, OHM120, OH358SA, OHSK120, OHSK125, OHSK130 with Briggs Intek model "20" and "21" engines, primarily on snow blowers., Briggs & Stratton

$24.00

In Stock:7

Sleeve-34-1x220-Key

, 2.20" Long, to go from 3/4" shaft to 1" shaft including a stepped key from 3/16" to 1/4", Unbranded

$19.95

In Stock:28

Questions? Email us directly:

Required Fields *

General Disclaimer

While we may have sold many engines listed above to be used for a John Deere 828D Snow Blower Category, we are NOT claiming these are exact replacements unless the product notes explicitly say so. Many original equipment engines may no longer be in production because of obsolescence or EPA regulations, so in some cases there may not be an exact replacement available. Our intention here is to show that other customers have utilized these in the equipment shown, but may have had to make some modifications to do so. If we know of any required changes, we will list those, however, some adapting during installation should be expected.