Jacobsen Imperial 626 Snow Blower Category

Original Model: Tecumseh H60-75447n

This series of engine is no longer available. It had a 1" x 3" shaft.

Additional Info
The wider OHV engine should work in there. You would have to purchase the sleeve to take care of the shaft difference. Please note...If your key stock is built into your pulley, this sleeve will not work for you. If your pulley will fit on a shorter shaft you could possibly use the engines with a 3/4" diameter shaft with the sleeve.

Parts List

3 Products

Shaft key

KeyStk-T-.188x.25x2.20

Stepped key stock from 3/16" to 1/4" x 2.20" long, Unbranded

$8.95

In Stock:230

KeyStk-T-.188x.25x2.20X.344

Stepped key stock from 3/16" to 1/4" x 2.20" long x .344" overall height, Unbranded

$19.95

In Stock:74

Sleeve-78-1x220

Sleeve, 2.20" Long, to go from 7/8" shaft to 1" shaft

$19.95

In Stock:2

Questions? Email us directly:

Required Fields *

General Disclaimer

While we may have sold many engines listed above to be used for a Jacobsen Imperial 626 Snow Blower Category, we are NOT claiming these are exact replacements unless the product notes explicitly say so. Many original equipment engines may no longer be in production because of obsolescence or EPA regulations, so in some cases there may not be an exact replacement available. Our intention here is to show that other customers have utilized these in the equipment shown, but may have had to make some modifications to do so. If we know of any required changes, we will list those, however, some adapting during installation should be expected.