Husqvarna ST624E Snow Blower Category
Original Model: HSK60-76010C
This has a single shaft that is 3/4" x 2-5/16". You can check out the engines listed here to see if you think it will work for you. The newer overhead valve engines have the same mounting but the engines are about 2" wider and 2" taller than the flathead engines (non overhead valve). The width will be 2" wider toward the right side as you are looking at the shaft. You will have to make sure that this width difference will not interfere with anything like the control chute rod.
Questions? Email us directly:
While we may have sold many engines listed above to be used for a Husqvarna ST624E Snow Blower Category, we are NOT claiming these are exact replacements unless the product notes explicitly say so. Many original equipment engines may no longer be in production because of obsolescence or EPA regulations, so in some cases there may not be an exact replacement available. Our intention here is to show that other customers have utilized these in the equipment shown, but may have had to make some modifications to do so. If we know of any required changes, we will list those, however, some adapting during installation should be expected.