Toro 724 Snow Blower Category
Original Model: Tecumseh H70-130176F
The H70-130176F has a 1"x 3" shaft. The newer style engines have a thicker mounting base. If you have studs for mounting, you may have to knock them out and use longer bolts to mount the engine. If you have any other model of engine, you may have a different shaft size. If you buy an engine with a 3/4" or 7/8" shaft, you will need to buy the sleeve kit for it also.
Additional Info
A customer said that this he has an older unit that has 3 to 4" clearance between the control chute rod and the engine and that the control chute rod arm can be adjusted for more clearance. Due to this information you should be able to use the wider overhead valve engines. The pulley looks large enough to be able to use a shorter shaft and use a bolt and washer to thread into the end of the shaft to hold the pulley on.
Parts List
3 ProductsShaft key
KeyStk-T-.188x.25x2.20
Stepped key stock from 3/16" to 1/4" x 2.20" long, Unbranded
KeyStk-T-.188x.25x2.20X.344
Stepped key stock from 3/16" to 1/4" x 2.20" long x .344" overall height, Unbranded
Sleeve-34-1x220-Key
, 2.20" Long, to go from 3/4" shaft to 1" shaft including a stepped key from 3/16" to 1/4", Unbranded
Questions? Email us directly:
General Disclaimer
While we may have sold many engines listed above to be used for a Toro 724 Snow Blower Category, we are NOT claiming these are exact replacements unless the product notes explicitly say so. Many original equipment engines may no longer be in production because of obsolescence or EPA regulations, so in some cases there may not be an exact replacement available. Our intention here is to show that other customers have utilized these in the equipment shown, but may have had to make some modifications to do so. If we know of any required changes, we will list those, however, some adapting during installation should be expected.