Call us:800-321-6725

Repower old Equipment

Snapper Rear Engine Rider Category

Available replacement parts listed below, please click product number to view more information about each replacement part.

Original Model: Various Models

The 8hp Briggs engines had a 3/4" threaded muffler port, the 9hp engines on up have 1" muffler ports, except OHV models which do not have internal threads.

The Briggs OHV 21**** series engines will replace an L-Head Briggs even if the tank is behind the seat.
If you buy an OHV engine to replace a L-Head engine, you will need to buy a muffler also, which may require you to remove the back right post for the normal muffler style to fit. The BS-Muffler-38 works well if you use a bagger.
The throttle linkage on the OHV Briggs engines run horizontally instead of vertically, you may have to get a longer cable for this to work correctly.

If you use a bagger, our 219807-0001-Z1 Kit (Engine, Muffler (BS-Muffler-38), & Exhaust Gasket) will work very well.

If you have the fuel tank about the left rear wheel, our TE-Tank-34186 will fit inside the bracket and work just fine.

Product NumberBrand DescriptionTypeQtyOur Price
Questions? Email us directly:
General Disclaimer

While we may have sold many engines listed above to be used for a Snapper Rear Engine Rider Category, we are NOT claiming these are exact replacements unless the product notes explicitly say so. Many original equipment engines may no longer be in production because of obsolesence or EPA regulations, so in some cases there may not be an exact replacement available. Our intention here is to show that other customers have utilized these in the equipment shown, but may have had to make some modifications to do so. If we know of any required changes, we will list those, however, some adapting during installation should be expected.