Call us:800-321-6725
  • MY ACCOUNT
  • CONTACT US
  • VIEW CART

Repower old Equipment

Snapper 281013BE Category

Available replacement parts listed below, please click product number to view more information about each replacement part.

Original Model: Briggs 10HP 254707

The 8hp Briggs engines had a 3/4" threaded muffler port, the 9hp engines on up have 1" muffler ports, except OHV models which do not have internal threads. If you buy an OHV engine to replace a L-Head engine you will need to buy a muffler also. If you are installing an OHV in the place of an L-Head you will have to remove the back right post for the muffler to fit on there. I am told that there is a Snapper muffler available Part #7074453 that fits perfectly and exhaust out the side and you can still use your bagger, however I have not tried this and we are not a Snapper dealer. The Briggs 21**** series engines will replace an L-Head Briggs even if the tank is behind the seat. The throttle linkage on the new Briggs engines run horizontally instead of vertically, you may have to get a longer cable for this to work correctly. If you have the fuel tank about the left rear wheel, our TE-Tank-34186 will fit inside the bracket and work just fine.

Product NumberBrand DescriptionTypeQtyOur Price
Questions? Email us directly:
General Disclaimer

While we may have sold many engines listed above to be used for a Snapper 281013BE Category, we are NOT claiming these are exact replacements unless the product notes explicitly say so. Many original equipment engines may no longer be in production because of obsolesence or EPA regulations, so in some cases there may not be an exact replacement available. Our intention here is to show that other customers have utilized these in the equipment shown, but may have had to make some modifications to do so. If we know of any required changes, we will list those, however, some adapting during installation should be expected.