Bolens 724 Snow Blower Category
Original Model: Tecumseh H70-130165F
This has a 1"x 2-7/8" shaft, we have a sleeve kit available to go from a 7/8" shaft to the 1" shaft. Please note: If your key stock is built into your pulley, this sleeve will not work for you. Note: the newer overhead valve engines are about 2" wider toward the right side as you are looking at the shaft side of the engine. You will have to determine that this will not interfere with your control chute rod. Note: if you use the OH195SA-72568 engine you will not be able to use the starter if you are in the USA due to the starter having a 220 volt European plug on it. This engine does not include a fuel tank and we do not have it in stock.
Parts List
2 ProductsShaft key
KeyStk-T-.188x.25x2.20
Stepped key stock from 3/16" to 1/4" x 2.20" long, Unbranded
KeyStk-T-.188x.25x2.20X.344
Stepped key stock from 3/16" to 1/4" x 2.20" long x .344" overall height, Unbranded
Questions? Email us directly:
General Disclaimer
While we may have sold many engines listed above to be used for a Bolens 724 Snow Blower Category, we are NOT claiming these are exact replacements unless the product notes explicitly say so. Many original equipment engines may no longer be in production because of obsolescence or EPA regulations, so in some cases there may not be an exact replacement available. Our intention here is to show that other customers have utilized these in the equipment shown, but may have had to make some modifications to do so. If we know of any required changes, we will list those, however, some adapting during installation should be expected.