Bolens 624 Snow Blower Category
Original Model: Tecumseh H60-75493U
This engine has a 1" x 2-51/64" shaft on it. Note: From the pictures the control chute rod sits low enough to not interfere with the newer engines which are wider. This has a 1" x 2-7/8" shaft, we have a sleeve kit available to go from a 7/8" shaft to the 1" shaft. Please note: If your key stock is built into your pulley, this sleeve will not work for you. Note: if you use the OH195SA-72568 engine you will not be able to use the starter if you are in the USA due to the starter having a 220 volt European plug on it. Also note the engine does not come with a fuel tank. If you purchase this engine you would also have to purchase a new tank. We do not have the thank for this engine.
Parts List
2 ProductsShaft key
KeyStk-T-.188x.25x2.20
Stepped key stock from 3/16" to 1/4" x 2.20" long, Unbranded
KeyStk-T-.188x.25x2.20X.344
Stepped key stock from 3/16" to 1/4" x 2.20" long x .344" overall height, Unbranded
Questions? Email us directly:
General Disclaimer
While we may have sold many engines listed above to be used for a Bolens 624 Snow Blower Category, we are NOT claiming these are exact replacements unless the product notes explicitly say so. Many original equipment engines may no longer be in production because of obsolescence or EPA regulations, so in some cases there may not be an exact replacement available. Our intention here is to show that other customers have utilized these in the equipment shown, but may have had to make some modifications to do so. If we know of any required changes, we will list those, however, some adapting during installation should be expected.