Call us:800-321-6725

Repower old Equipment

Ariens 924028 Category

Available replacement parts listed below, please click product number to view more information about each replacement part.

Original Model: Tecumseh is H70

The models with a H50-H60-H70 engines on them typically have a 1"x2-3/8" shaft on them. The Briggs Intek OHV 5-7.75hp engines will normally replace these engines. You would likely have to knock the mounting studs out of the frame and use normal bolts to bolt it down. (IF YOU BUY AN ENGINE WITH A 3/4" SHAFT ON IT YOU WILL HAVE TO CHANGE YOUR PULLEYS) Or purchase the sleeve kit to take the diameter from 3/4" to 1" If your chute control rod goes above the engine you would have to buy the same series of engine or we wouldn't have anything for you unless you can redo the crank and move it out of the way.

Product NumberBrand DescriptionTypeQtyOur Price
Questions? Email us directly:
General Disclaimer

While we may have sold many engines listed above to be used for a Ariens 924028 Category, we are NOT claiming these are exact replacements unless the product notes explicitly say so. Many original equipment engines may no longer be in production because of obsolesence or EPA regulations, so in some cases there may not be an exact replacement available. Our intention here is to show that other customers have utilized these in the equipment shown, but may have had to make some modifications to do so. If we know of any required changes, we will list those, however, some adapting during installation should be expected.