Call us:800-321-6725
  • MY ACCOUNT
  • CONTACT US
  • VIEW CART

Repower old Equipment

Troy-Bilt Pony Tiller Category

Available replacement parts listed below, please click product number to view more information about each replacement part.

Original Model: 130292 5hp Briggs with PTO Shaft
The original has a 2nd PTO shaft to run the reverse gear on the tiller.

The OHV engines listed here with "-TROY" at the end, are designed to work on this tiller.
They will include instructions, new bolts, spacers, and a drive belt with the engine to allow you to install the kit on the tiller.


If you buy an engine not marked "-TROY", it will not have the extra PTO shaft, and you will no longer have reverse.



If your tiller has an idler pulley on the engine, like the one below (to the far left), you will need to order the Troy-Idle-Pull-Kit separately for $16, or order the 12S492-Troy-Z1 which is the Repower Kit plus the Idle Pulley Kit.


Troy-Idle-Pull-Kit installed on engine. Remove pulley from old engine and install on threaded stud of pulley kit.



The engines listed below will fit your Troy-Bilt Pony tiller.
If you email us asking what engine will fit we will refer you right back to this link.

Product NumberBrand DescriptionTypeQtyOur Price
Questions? Email us directly:
General Disclaimer

While we may have sold many engines listed above to be used for a Troy-Bilt Pony Tiller Category, we are NOT claiming these are exact replacements unless the product notes explicitly say so. Many original equipment engines may no longer be in production because of obsolesence or EPA regulations, so in some cases there may not be an exact replacement available. Our intention here is to show that other customers have utilized these in the equipment shown, but may have had to make some modifications to do so. If we know of any required changes, we will list those, however, some adapting during installation should be expected.