BS-696458 10-16 Amp Alternator, fits most Briggs engines from 7-26hp, has to use 691185 or 394890 regulator Briggs & Stratton Engine Parts
Key Specs:
Shipping Weight: 2
Condition: NewProduct Condition Definitions
Items are brand new. A typical scratch and dent item was purchased without its original box, and has much more handling than most items. Many of these are old stock, and may have some shaft surface rust from the extended inventory period. These may have minor cosmetic dings and paint scratches, but nothing that will affect the operation of the item. These may have been removed from new equipment and possibly started to assure their operation before being sold. These are new items, not previously sold, with full manufacturer's warranty.
Means that the item has been serviced by the original manufacturer, after being returned for one of a variety of reasons: - Item was missing parts when received by the store. - Item had scratches or dents on item when received by the store, and may come with scratches or dents, with paint possibly faded or flaking. - Item was purchased by a consumer and didn't work right away and they returned it to the store. The store then returned the item to the factory. - Warranty on this item (pressure washer pump or generator) is from Small Engine Warehouse and covers defects in material and workmanship for a period of 90 days from the date on the invoice. - Warranty on the item is from the manufacturer and depending on model is either 1 or 2 years, covers defects in material and workmanship, service on item can be obtained from any Factory Authorized Service Center. - These are not brand new. Every item has been ran.
Items are not brand new. They normally have run time on the item of several hours. A typical take-off item was removed from a non-working pressure washer or generator. All take-off items are started, run, and repaired (if necessary) by us. The warranty is from us, not the manufacturer, for a period of 30 days from the date on the invoice.
Minor imperfections generally occur when the manufacturer makes the seat and while injecting the foam it doesn't fully fill out the vinyl or cloth and has a "wrinkle" that at first glance may appear to be a rip but upon further inspection is just an "indent" in the material.
Warranty: No Returns on Electrical Items
This only works with a regulator that has two yellow wires on it with a yellow connector and a single red wire with red connector. These were either removed from new engines or are made by an aftermarket company. These may be slightly rusty due to storage conditions There is no return on any electric part
Manual not available for this item.Download: Owner's Manual
Product drawing not available for this item.Download: Product Drawing
Item link not available for this item.Item Link: BS-696458
